Omron Q2A Series Technical Manual page 389

◆
Keypad Options
Name
WV001 (1 m [3.3 ft] length)
LCD Operator Extension Cable
WV003 (3 m [9.8 ft] length)
Installation Support Set A 900-192-933-001
Installation Support Set B 900-192-933-002
◆
Attachments
Name
900-193-209-001
External Heatsink Mount Kit 900-193-209-002
900-193-209-003
900-192-121-001
900-192-121-002
UL Type 1 Kit
900-192-121-003
900-192-121-004
900-192-121-005
Braking Resistor Installation
EZZ020805A
Attachment
External Mounting Attachment
EZZ021711A
for Braking Unit Fin
◆
Engineering Tools
Name
Q2edit
Q2dev
◆
Option Cards
Name
Complementary Type PG PG-B3
Motor PG Feedback Line Driver
PG-X3
Interface
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
Model
To connect the keypad and drive.
This option is an RJ-45, 8-pin straight-through UTP CAT5e cable.
To attach the keypad to the control panel. This option uses screws.
To attach the keypad to the control panel. This option uses nut clamps.
Use this option when weld studs are located in the control panel.
Model
Use this option to install the heatsink outside of the control panel.
Note:
When you use external heatsink mounting, it may be necessary to decrease the current.
To change an open chassis type (IP20) drive to an enclosed wall-mounted type (UL Type 1) drive.
To install a braking resistor to a drive.
To install the heatsink for the braking unit outside of the control panel.
Model
- To use a PC to configure drives and manage parameters.
To use a PC to do advanced drive programming.
-
Model
This option is for use with PG V/f Control and OLVector control methods. The
drive detects motor rotation speed from the pulse generator as feedback. The
drive can then enable control of the output frequency keep a constant motor
speed.
• Complementary output PG support
• A, B, and Z pulse (Three-phase pulse) input
• Maximum input frequency: 50 kHz
• Pulse monitor output: Open-collector (24 V, maximum of 30 mA)
• Encoder power supply: 12 V, maximum 200 mA current.
This option is for use with CLVector, PG V/f Control, and PM CLVector
control methods. The drive detects motor rotation speed from the pulse
generator as feedback. The drive can then enable control of the output
frequency keep a constant motor speed.
• RS-422 output encoder support
• A, B, and Z pulse (differential pulse) input
• Maximum input frequency: 300 kHz
• Pulse monitor: Equivalent to RS-422 level
• Encoder voltage output: 5 V or 12V, maximum 200 mA current
10.8 Peripheral Devices and Options
Purpose
Purpose
Purpose
Purpose Document No.
TOBPC73060075
TOBPC73060076
10
389