Start Data Logging; Set Data To Log - Omron Q2A Series Technical Manual

1.
Push ( ) to show the HOME screen.
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
5.
Push or
This operation will initialize all parameters.
6.
Push or
7.
For the next steps, follow the instructions shown on the keypad until the "Parameter Change Confirmation
Screen" is shown.
8.
In the parameter change confirmation screen, push
select [Apply each parameter] at the bottom of the screen and push
Note:
To change a parameter, push
screen.
9.
Push or
The Q2 Wizard procedure is complete.
◆

Start Data Logging

The data log function keeps a record of a maximum of 10 drive monitors. The procedure in this section shows
how to start logging data.
1.
Make sure that a microSD card is inserted in the keypad.
2.
Push ( ) to show the HOME screen.
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
3.
Push ( ).
4.
Push or
5.
Push or
6.
Push or
• [Yes]: Data logging starts.
• [No]: Data logging will not start.
If the drive was logging data when you entered the command, the drive will ask to stop data logging.
◆

Set Data to Log

■
Set Monitor to Log
The procedure in this section shows how to set the monitor for which to log data.
1.
Push ( ) to show the HOME screen.
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
, push ( ) to show [
to select [Wizard & Autotuning], then push
to select [Q2 Wizard], then push
to select [Yes], then push
to select the item to set, then push
or to select the parameter to change, then push
to select [Yes], then push
, push ( ) to show [
to select [Monitor & Diagnostics], then push
to select [Data Logger], then push
to select [Yes] or [No], then push
, push ( ) to show [
] on .
.
.
.
.
or to examine the changed parameter, then
.
to apply the parameter settings.
] on .
.
.
.
] on .
4.5 Keypad Operation
to show the parameter setting
141
4