Omron Q2A Series Technical Manual page 133

Push .
8.
Push or
9.
Push or
• Push (Default) to set the parameters to the factory default.
• Push (Min/Max) to move between the minimum value and maximum value.
10.
Push to keep the changes.
11.
Push or
12.
Push or
• Push (Default) to set the parameters to the factory default.
• Push (Min/Max) to move between the minimum value and maximum value.
13.
Push to keep the changes.
14.
Push ( ).
If necessary, use the same procedure to set [Custom Monitor 2].
■
Set the Time Scale for the Trend Plot Monitor
The procedure in this section shows how to set the time scale for the trend plot monitor.
1.
Push ( ) to show the HOME screen.
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
5.
Push or
6.
Push or
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
to select [Trend Plot 1 Min Scale Value], then push
to select the specified digit, then push
to select [Trend Plot 1 Max Scale Value], then push
to select the specified digit, then push
, push ( ) to show [
to select [Monitor & Diagnostics], then push
to select [Trend Plot], then push
to select [Trend Plot Time Scale Setting], then push
to select the specified digit, then push
.
or to select the correct number.
.
or to select the correct number.
] on .
.
( ).
.
or to select the correct number.
4.5 Keypad Operation
133
4