The configuration procedure is complete.
◆
Show Monitors as Bar Graphs
The procedure in this section shows how to show a specific monitor as a bar graph. You can show a maximum of
three.
1.
Push
(
) to display the HOME screen.
Note:
• [
Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [
] is not shown on
2.
Push
( ).
3.
Push
or
4.
Push
or
The screen will show the monitors as shown in this figure.
◆
Set the Monitors to Show as Analog Gauges
The procedure in this section shows how to show the frequency reference monitor as an analog gauge.
1.
Push
(
) to show the HOME screen.
Note:
• [
Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [
] is not shown on
2.
Push
( ).
3.
Push
or
4.
Push
or
5.
Push
.
6.
Push
or
Enter the three digits in "x-xx" part of monitor Ux-xx to identify which monitor to output. For example, to
show monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
Push
.
The configuration procedure is complete.
◆
Display Monitors as an Analog Gauge
The following explains how to display the contents selected for a monitor as an analog gauge.
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
, push
( ) to show [
to select [Monitor & Diagnostics], then push
to select [Bar Graph], and push
, push
( ) to show [
to select [Monitor & Diagnostics], then push
to select [Analog Gauge], then push
to select the monitor number to register.
] on
.
.
.
] on
.
.
(
).
4.5 Keypad Operation
131
4