Set Monitoring Items To Be Shown As A Trend Plot - Omron Q2A Series Technical Manual

4.5 Keypad Operation
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
It will be displayed as follows.
◆

Set Monitoring Items to be Shown as a Trend Plot

You must set the items in this figure to display as a trend plot.
A - Monitor Parameter 1 (set with
B - Monitor Parameter 2 (set with
C - Trend Plot 2 Scale Max/Min Scale
■
Select Monitor Items to Show as a Trend Plot
The procedure in this section shows how to show the frequency reference monitor as a trend plot.
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
5.
Push or
6.
Push .
7.
Push or
When the U parameters are on the display as "Ux-xx", the three digits in "x-xx" identify which monitor to
output. For example, to show monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
132
) to show the HOME screen.
, push ( ) to show [
to select [Monitor & Diagnostics], then push
to select [Analog Gauge], then push
[Custom Monitor 1])
[Custom Monitor 2])
Value
) to show the HOME screen.
, push ( ) to show [
to select [Monitor & Diagnostics], then push
to select [Trend Plot], then push
to select [Custom Monitor 1], then push
to select the monitor number to register.
] on .
.
.
D - Trend Plot Time Scale
E - Trend Plot 1 Scale Max/Min Scale
Value
] on .
.
( ).
.
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual