Show Custom Monitors; Set The Monitors To Show As A Bar Graph - Omron Q2A Series Technical Manual

4.5 Keypad Operation
The configuration procedure is complete.
◆

Show Custom Monitors

The procedure in this section shows how to show the registered custom monitors.
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
The keypad shows the selected monitor as shown in this figure.
• When there are a minimum of two screens, push
• If you registered only one custom monitor to [Custom Monitor 1], the screen will show only one monitor. If you
registered custom monitors only to [Custom Monitor 1] and [Custom Monitor 2], the screen will show only two
monitors.
• Push
for 2 s to toggle between 3-line view and 6-line view.
• To remove monitors from the Custom Monitor list, chose '0' [Through Mode].
◆

Set the Monitors to Show as a Bar Graph

The procedure in this section shows how to show the frequency reference monitor as a bar graph.
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
5.
Push or
6.
Push .
7.
Push or
Enter the three digits in "x-xx" part of monitor Ux-xx to identify which monitor to output. For example, to
show monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
Push .
130
) to show the HOME screen.
, push ( ) to show [
to select [Monitor & Diagnostics], then push
to select [Custom Monitors], then push
) to show the HOME screen.
, push ( ) to show [
to select [Monitor & Diagnostics], then push
to select [Bar Graph], then push
to select the location to store the monitor, then push
to select the monitor number to register.
] on .
.
.
or to switch between screens.
] on .
.
( ).
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
.