4.5 Keypad Operation
4.
Push
or
5.
To re-edit a parameter, push
6.
Push
or
7.
When you are done changing the value, push
The parameter revision procedure is complete.
◆
Restore Modified Parameters to Defaults
This procedure will set all parameters with changed values to their default settings.
1.
Push
(
Note:
• [
Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [
] is not shown on
2.
Push
( ).
3.
Push
or
4.
Push
or
5.
Push
(Default).
6.
Push
.
The modified parameter is now set to its default value.
◆
Show Fault History
You can examine a maximum of 10 fault codes, and dates and times when the faults occurred.
Note:
• Make sure that you first set the date and time on the keypad if you will monitor the date and time of the faults.
• If the keypad does not have a clock battery, you must set the date and time each time you energize the drive.
1.
Push
(
Note:
• [
Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [
] is not shown on
2.
Push
( ).
3.
Push
or
4.
Push
or
5.
Push
or
◆
Auto-Tuning the Drive
Auto-Tuning uses motor characteristics to automatically set drive parameters.
Refer to the motor nameplate or the motor test report for the necessary information for Auto-Tuning.
138
to show the parameter to check.
or
to select the digit, then push
) to show the HOME screen.
, push
( ) to show [
to select [Modified Parameters], then push
to select the parameters to return to their default settings, then push
) to show the HOME screen.
, push
( ) to show [
to select [Monitor & Diagnostics], then push
to select [Fault Log], then push
to show the fault history you will examine.
Figure 4.9 Motor Nameplate (Example)
, select the parameter to edit, then push
or
to change the value.
.
] on
.
.
] on
.
.
.
.
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
.