Set Backlight To Automatically Turn Off - Omron Q2A Series Technical Manual

4.5 Keypad Operation
3.
Push or
4.
Push or
5.
Push or
6.
Push or
7.
Push or
The setting procedure is complete.
■
Set the Sampling Time
The procedure in this section shows how to set the sampling time for data logging.
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
5.
Push or
6.
Push or
7.
When you are done changing the value, push
The procedure to set the sampling time is complete.
◆

Set Backlight to Automatically Turn OFF

You can set the backlight of the keypad screen to automatically turn OFF after a set length of time since the last
key operation on the keypad. The procedure in this section shows how to turn ON and turn OFF the backlight.
1.
Push (
Note:
• [ Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [ ] is not shown on
2.
Push ( ).
3.
Push or
4.
Push or
5.
Push or
• [ON]: Backlight is always ON
• [OFF]: Backlight turns OFF after set length of time.
6.
Push (
7.
Push .
8.
To adjust the time to turn off LCD backlight, push
change the value.
9.
When you are done changing the value, push
The procedure to set the backlight to turn OFF automatically is complete.
142
to select [Monitor & Diagnostics], then push
to select [Data Logger], then push
to select [Log Monitor], then push
to select the save-destination monitor parameter, then push
to select the monitor number to be logged, then push
) to show the HOME screen.
, push ( ) to show [
to select [Monitor & Diagnostics], then push
to select [Data Logger], then push
to select [Log Sample Lapse], then push
to select the digit, then push
) to show the HOME screen.
, push ( ) to show [
to select [Configuration], then push
to select [Backlight], then push
to select [ON] or [OFF], then push
).
.
( ).
.
] on .
.
(Setup).
.
or to change the value.
.
] on .
.
.
.
or to select the digit, then push
.
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
.
.
or to