Moving The Drive; Vertical Suspension; Horizontal Suspension - Omron Q2A Series Technical Manual

2.4 Moving the Drive

2.4

Moving the Drive

Obey local laws and regulations when moving and installing this product.
CAUTION! Crush Hazard. Do not hold the drive by the front cover or terminal cover. Tighten the screws correctly before moving
the drive. Failure to obey can cause minor to moderate injury.
< 15 kg (33 lbs.)
≥ 15 kg (33 lbs.)
Use the hanging brackets attached to the drive to temporarily lift the drive when you install the drive to a control
panel or wall or when you replace the drive. Do not let the drive stay vertically or horizontally suspended or move
the drive over a long distance while it is suspended.
◆

Vertical Suspension

To vertically suspend the drive with the hanging brackets, lift the drive with this procedure:
WARNING! Crush Hazard. Use screws to correctly attach the drive front cover, terminal blocks, and other drive components
before hanging the drive vertically. Failure to obey can cause serious injury or death from falling equipment.
WARNING! Crush Hazard. Prevent more than 1.96 m/s
cause death or serious injury from falling equipment.
WARNING! Crush Hazard. Do not try to flip over a hanging drive or leave a hanging drive unattended. Failure to obey can
cause death or serious injury from falling equipment.
1.
Put wire through the 2 holes in the hanging brackets.
A - Suspension angle of at least 50
2.
Use a crane to gradually wind up the wire. Visually make sure that there is sufficient tension in the wire,
then lift the drive to its correct location.
3.
Prepare the control panel for installation, then lower the drive.
Note:
When lowering the drive, stop before the drive touches the floor, then slowly lower it the remaining distance.
◆

Horizontal Suspension

Put the drive on the ground horizontally. Connect wires to the 4 hanging brackets and use a crane to lift the drive.
WARNING! Crush Hazard. Prevent more than 1.96 m/s
cause death or serious injury from falling equipment.
34
Drive Weight
Model
4075 to 4168
degrees
Figure 2.5 Vertical Suspension
Model
4208 to 4675
Persons Necessary to Move the Drive
2 + using appropriate lifting equipment
2 (0.2 G) vibration and impact to a hanging drive. Failure to obey can
B - Hanging bracket (2)
2
(0.2 G) vibration and impact to a hanging drive. Failure to obey can
1
Suspension Method
Vertical Suspension
Suspension Method
Horizontal Suspension
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual