Warning Label Content And Location - Omron Q2A Series Technical Manual

i.1 Safety Information
Use a motor that provides insulation correct for PWM drives.
Failure to obey can cause a short circuit or ground fault from insulation deterioration.
Observe correct electrostatic discharge (ESD) procedures when touching the drive and circuit
boards.
Failure to obey can cause ESD damage to the drive circuitry.
Do not do a withstand voltage test or Megger test on the drive.
Failure to obey can cause damage to the drive.
Do not connect or operate damaged equipment or equipment with missing parts.
Failure to obey can cause damage to the drive and connected equipment.
If it is necessary to use disinfectant or to debug wood material for packaging, use a method
other than steam. Example: Heat treatment (core at 56 °C [133 °F] or higher for more than 30
minutes)
Gas steam from fumigated wooden packaging materials can cause damage to electrical components. Halogen
disinfectants (fluorine, chlorine, bromine, and iodine) erode capacitors, and DOP gas (phthalic acid ester) cracks
resin materials. Do all treatment procedures before packaging components.
◆

Warning Label Content and Location

Use the drive as specified by the warning label on the drive.
A - Warning label
16
NOTICE
Figure i.1 Warning Label Content and Location
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual