Switches And Jumpers On The Terminal Board - Omron Q2A Series Technical Manual

3.5 Control Circuit Wiring
3.
Put the cable through the clearance in the wiring cover.
4.
Install the USB port board, front cover, and the keypad to their initial positions.
◆

Switches and Jumpers on the Terminal Board

The terminal board has switches to adapt the drive I/Os to the external control signals.
Set the switches to select the functions for each terminal.
Posi
Switch
tion
A DIP switch S2
B Jumper switch S5
DIP switch S1-1
C DIP switch S1-2
DIP switch S1-3
D DIP switch S4
92
Figure 3.41 Control Circuit Wiring
Figure 3.42 Locations of Switches
Table 3.14 I/O Terminals and Switches Functions
Terminal
Enables and disables the Modbus communications termination
-
resistor.
AO1, AO2 Sets terminals AO1 and AO2 to voltage or current output.
AI1 Selects the input signal type (voltage/current).
AI2 Selects the input signal type (voltage/current).
AI3 Selects the input signal type (voltage/current).
AI3 Selects MFAI or PTC input.
Function
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
Default Setting
OFF
AO1: V (voltage output)
AO2: V (voltage output)
V (voltage input)
I (current input)
V (voltage input)
AI (analog input)