2.6 Install the Keypad to a Control Panel or Another Device
A - Keypad
B - Keypad connector
3.
Put the keypad on the outside of the control panel.
Use M3 screws (6 mm (0.2 in.) depth cross-recessed pan head screws) to attach the keypad from the
inside. Tighten the screws to a tightening torque of 0.49 N∙m to 0.73 N∙m (4.34 lb.∙in. to 6.46 lb.∙in.).
A - Keypad
B - M3 screws
4.
Use the remote control extension cable to connect the keypad to the drive.
A - Remote control extension
B - Communications connector
C - Drive
Figure 2.13 Connect the Drive and Keypad with the Remote Control Extension Cable
◆
Install Inside Control Panel
To attach the keypad inside of the control panel, you must purchase the installation support set, which is sold
separately. Contact the manufacturer or your nearest sales representative to order mounting brackets and mounting
hardware.
38
Figure 2.11 Remove the Keypad
Figure 2.12 Mount to the Outside of Control Panel
C - Holder
C - Control panel
D - Keypad
E - Cable connector
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual