Remove The Front Cover Of Drive Models 4208 - 4675 - Omron Q2A Series Technical Manual

1.
Wire the drive and other peripheral devices.
2.
Reverse the steps to reattach the cover.
Note:
• Wire the grounding terminals first, main circuit terminals next, and control circuit terminals last.
• Make sure that you do not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
• Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 lb.∙in. to 11.77 lb.∙in.).
3.
Reattach the keypad to the original position.
◆

Remove the Front Cover of Drive Models 4208 - 4675

DANGER! Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an energized drive. Before servicing,
disconnect all power to the equipment and wait for the time specified on the warning label at a minimum. The internal capacitor
stays charged after the drive is de-energized. The charge indicator LED extinguishes when the DC bus voltage decreases
below 50 Vdc. When all indicators are OFF, remove the covers before measuring for dangerous voltages to make sure that the
drive is safe. Failure to obey will cause death or serious injury.
1.
Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Crush Hazard. Only loosen the cover screws. Do not fully remove the cover screws. Make sure that the
terminal covers for larger drives do not fall. Missing cover screws can cause the terminal cover to fall and cause injury.
2.
Pull the terminal cover away from the drive.
3.
Remove the keypad, and keypad connector, then insert the end of the keypad connector that has the tab
into the keypad connector holder on the front cover.
A - Keypad
B - Keypad connector
Figure 2.25 Remove the Terminal Cover, Keypad, and Keypad Connector
SIEPYEUOQ2A01A AC Drive Q2A Technical Manual
Figure 2.23 Reattach the Front Cover
Figure 2.24 Loosen the Terminal Cover Mounting Screws
2.7 Removing/Reattaching Covers
C - Connector holder
2
43