Dlp-B58 Provision Remote Access To The Ons 15327 - Cisco ONS 15327 Procedure Manual

Chapter 2 Connect the PC and Log into the GUI
•
•
Return to your originating procedure (NTP).
Step 5

DLP-B58 Provision Remote Access to the ONS 15327

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Connect the modem to the RJ-45 (LAN) port on the XTC.
Step 1
While referring to the modem documentation, complete the following tasks to provision the modem for
Step 2
the ONS 15327:
•
•
•
Note
Return to your originating procedure (NTP).
Step 3
March 2003
Choose Direct connection to the Internet to bypass the proxy server.
Choose Manual proxy configuration to add exceptions to the proxy server, then click View. In the
Manual Proxy Configuration dialog box under Exceptions, enter the IP addresses of the ONS 15327
nodes that you will access. Separate each address with a comma. Click OK to close each open dialog
box.
This task connects an ONS 15327 using a LAN modem.
Modem and modem documentation
NTP-B21 Set Up Computer for CTC, page 2-1
Required to access the Cisco Transport Controller
Onsite or remote
None
For CTC access, set the modem for Ethernet access.
Assign an IP address to the modem that is on the same subnet as the ONS 15327.
The IP address the modem assigns to the CTC computer must be on the same subnet as the modem
and the ONS 15327.
For assistance on provisioning specific modems, contact the Cisco Technical Assistance Center.
NTP-B22 Set Up CTC Computer to Connect to the ONS 15327
Cisco ONS 15327 Procedure Guide, R4.0
2-21