Dlp-B112 Display Alarms And Conditions Using Time Zone; Dlp-B113 Synchronize Alarms - Cisco ONS 15327 Procedure Manual

NTP-B196 View Alarms, History, Events, and Conditions
Note
Note
Return to your originating procedure (NTP).
Step 4

DLP-B112 Display Alarms and Conditions Using Time Zone

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the Edit menu choose Preferences.
Step 1
The CTC Preferences Dialog box appears
Click the Display Events Using Each Node's Timezone check box.
Step 2
Click Apply and OK.
Step 3
Return to your originating procedure (NTP).
Step 4

DLP-B113 Synchronize Alarms

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15327 Procedure Guide, R4.0
6-10
Setting the Maximum History Entries value to the high end of the range uses more CTC memory
and could impair CTC performance.
This task changes the maximum history entries recorded for CTC sessions. It does not affect the
maximum number of history entries viewable for a network, node, or card.
Use this task to change the timestamp for events to the timezone of the
ONS node reporting the alarm. By default, the events timestamp is set to
the timezone for the CTC workstation.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning
Use this task to view ONS 15327 events at the card, node, or network level
and to refresh the alarm listing while troubleshooting so that you can check
for new and cleared alarms and conditions.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve
(Figure 6-4 on page 6-9).
Chapter 6 Manage Alarms
November 2004