Ntp-B108 Back Up The Database - Cisco ONS 15327 Procedure Manual

NTP-B108 Back Up the Database

NTP-B108 Back Up the Database
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You must back up and restore the database for each node on a circuit path in order to maintain a complete
Note
circuit.
The following parameters are not backed up and restored: node name, IP address, mask and gateway, and
Note
IIOP port. If you change the node name and then restore a backed up database with a different node
name, the circuits will map to the new node name. Cisco recommends keeping a record of the old and
new node names.
Step 1 Complete the
database backup. If you are already logged in, continue with Step 2.
Step 2 In node (default) view, click the Maintenance > Database tabs
Cisco ONS 15327 Procedure Guide, R4.0
14-6
This procedure stores a backup version of the XTC (software) database
on the workstation running CTC or on a network server.
None
None
Required. Cisco recommends performing a database backup at
approximately weekly intervals and prior to and after configuration
changes.
Onsite or remote
Superuser
"DLP-B 60 Log into CTC" task on page 2-23
Chapter 14
at the node where you will perform the
(Figure 14-5).
Maintain the Node
March 2003