Mitsubishi Electric GOT2000 Series Connection Manual page 1205

Step 5.
Set the protocol to TCP. Network No. and Station No. are not required to be changed (default) because
they are not used.
Step 6.
Double-click [GOT] of the PLC side I/F to display [PLC side I/F Detailed Setting of GOT].
Step 7.
Set the IP address and port No. in [Ethernet detail setting for PC and GOT connection].
Set the IP address and port No. to the same as the Ethernet download setting.
➠
22.6.1 (2) Ethernet download setting
Step 8.
The screen returns to [Transfer Setup]. Click [Connection Test] to check if Setting/Monitoring tool for C
Controller module has been connected to the motion controller (Q mode).
22.7 Personal Computer Side Setting
22
22 - 149