Connecting To C Controller Module (Q Series) - Mitsubishi Electric GT14 User Manual

Hide thumbs Also See for GT14:
Table of Contents

Advertisement

23.4.8 Connecting to C controller
module (Q Series)
This section describes the settings of the GOT and C
controller module (Q Series) in the following case of the
system configuration.
POINT
POINT
POINT
C Controller module (Q Series)
For details of C controller module (Q Series), refer to
the following manual.
C Controller Module User's Manual (Hardware,
Design, Function Explanation)
System configuration
[Controller Setting] and [Ethernet] of GT Designer3
<C controller module (Q Series)>
2
(The settings other than the following are
set to the default)
Network No.
PLC No.
IP address
Port No.
Communication
format
 Utility setting for C controller module (Q Series)
*1
These setting items do not exist on the PLC side. However,
the virtual values must be set on the GOT side.
 [Controller Setting] and [Ethernet] of GT
Designer3
<GOT>
(The settings other than the
following are set to the default)
Network No.
: 1
PLC No.
: 1
IP address
: 192.168.3.18
Port No.
: 5001
Communication
: UDP(fixed)
format
<C controller module (Q Series)>
1
(The settings other than the
following are set to the default)
Network No.
: 1 (virtual)
*1
PLC No.
: 2 (virtual)
*1
IP address
: 192.168.3.1
Port No.
: 5006(fixed)
Communication
: UDP(fixed)
format
: 1 (virtual)
*1
: 3 (virtual)
*1
: 192.168.3.2
: 5006(fixed)
: UDP(fixed)
Utility setting for C controller module (Q
Series)
(1) Q12DCCPU-V
Use SW3PVC-CCPU-J Ver.3.04E or later for the C
Controller module (Q Series) setting utility.
(a) Connection settings
Item
*1
192.168.3.3
Target module
Write authority
Mark the checkbox
User name
Password
Detailed settings
: Necessary
*1
If the IP address of the C controller module (Q Series) has
been changed, input the changed IP address or host name.
*2
If the account of the C controller module (Q Series) has been
changed, input the changed user name and password.
(b) Online operation
Item
Detailed settings
Refer to (3).
: Necessary
23. ETHERNET CONNECTION
23.4 PLC Side Setting
Setting necessity at
Set value
GOT connection
target
password
-
: As necessary
: Not necessary
Setting necessity at
Set value
GOT connection
: As necessary
: Not necessary
23 - 33
17
18
19
20
21
22
23
24

Advertisement

Table of Contents
loading

Table of Contents