Router Vrrp (Interface) - Allied Telesis x310-26FT Command Reference Manual

VRRP C
OMMANDS
( )
ROUTER VRRP INTERFACE

router vrrp (interface)

Overview Use this command to configure VRRP IPv4 and define the interface that will
participate in virtual routing to send and receive advertisement messages. This
command allows you to enter the Router Configuration mode.
Use the no variant of this command to remove the VRRP IPv4 configuration.
Disable the VRRP session before using the no variant of this command.
router vrrp <vrid> <interface>
Syntax
no router vrrp <vrid> <interface>
Mode Global Configuration
Usage Use the required <interface> placeholder to define the interface that will
participate in virtual routing. This interface is used for two purposes - to
send/receive advertisement messages and to forward on behalf of the virtual
router when in master state.
You can configure up to 255 IPv4 and 255 IPv6 VRRP instances. However,
configuring a high number of instances may adversely affect the device's
performance, depending on the device CPU, the other protocols it is running, and
whether you set the advertisement interval to less than 1 second.
See the
about VRRPv3 IPv4 configuration details.
Examples To enable a VRRP session with VR ID 5 on vlan1, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
To disable a VRRP session with VR ID 5 on vlan1, use the commands:
awplus(config-router)#
awplus(config-router)#
awplus(config)#
C613-50103-01 REV A
Parameter Description
<vrid>
<1-255> The ID of the virtual router VRRP IPv4 session to create.
<interface>
Specify the name of the interface that will participate in the virtual
routing. The interface must exist on the router. The interface
specified sends and receives VRRP IPv4 advertisement messages.
VRRP Feature Overview and Configuration Guide
configure terminal
router vrrp 5 vlan1
no router vrrp 5 vlan1
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
enable
disable
exit
for more information
1971