HP ProCurve 7102dl Reference Manual page 1421

SROS Command Line Interface Reference Guide
netbios-node-type <type>
Use the netbios-node-type command to specify the type of NetBIOS node used with Dynamic Host
Configuration Protocol (DHCP) clients. Use the no form of this command to remove a configured
NetBIOS node type.
Syntax Description
<type>
Default Values
<type>
Usage Examples
The following example specifies a client's NetBIOS node type as h-node:
ProCurve(config)#ip dhcp-server pool MyPool
(ProCurve(config-dhcp)#netbios-node-type h-node
Alternately, the following also specifies the client's NetBIOS node type as h-node:
ProCurve(config-dhcp)#netbios-node-type 8
5991-2114
Specifies the NetBIOS node type used with DHCP clients.
Valid node types are as follows:
b-node (1) - Broadcast node
p-node (2) - Peer-to-Peer node
m-node (4) - Mixed node
h-node (8) - Hybrid node (Recommended)
Alternately, the node type can be specified using the numerical value listed next to
the nodes above.
h-node (8) - Hybrid node
© Copyright 2007 Hewlett-Packard Development Company, L.P.
DHCP Pool Command Set
1419