HP ProCurve 7102dl Reference Manual page 1422

SROS Command Line Interface Reference Guide
network <address> [<subnet mask> or <prefix length>]
Use the network command to specify the subnet number and mask for an SROS Dynamic Host
Configuration Protocol (DHCP) server address pool. Use the no form of this command to remove a
configured subnet.
Syntax Description
<ip address>
<subnet mask>
<prefix length>
Default Values
By default, there are no configured DHCP address pools.
Usage Examples
The following examples show two different ways to configure an address pool subnet of 192.168.0.0 with a
16-bit subnet mask:
ProCurve(config)#ip dhcp-server pool MyPool
(ProCurve(config-dhcp)#network 192.168.0.0 255.255.0.0
or
ProCurve(config)#ip dhcp-server pool MyPool
ProCurve(config-dhcp)#network 192.168.0.0 /16
5991-2114
Specifies the IP address (in dotted decimal notation) of the DHCP address pool.
Optional. Specifies the network mask (subnet) for the address pool. If the subnet
mask is left unspecified, the DHCP server uses the Class A, B, or C natural mask.
Optional. Alternately, the prefix length may be used to specify the number of bits
that comprise the network address. The prefix length must be preceded by a
forward slash ( / ). For example, to
specify an IP address with a subnet mask of 255.255.0.0, enter /16 after the
address.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
DHCP Pool Command Set
1420