HP ProCurve 7102dl Reference Manual page 1412

SROS Command Line Interface Reference Guide
client-name <name>
Use the client-name command to specify the name of a Dynamic Host Configuration Protocol (DHCP)
client. Use the no form of this command to remove the configured client name.
Syntax Description
<name>
Note
The specified client name should not contain the domain name.
Default Values
By default, there are no specified client names.
Usage Examples
The following example specifies a client name of myclient:
ProCurve(config)#ip dhcp-server pool MyPool
ProCurve(config-dhcp)#client-name myclient
5991-2114
Identifies the DHCP client (example is client1) with an alphanumeric string (up to
32 characters in length).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
DHCP Pool Command Set
1410