3.15.3
B4-size recycled paper mode settings
Set this mode if the trailing edge of the paper gets caught by the exit section of the finisher while B4-
size recycled paper is used. This mode increases the paper exiting speed when the paper exits to the
movable tray in the sort mode, or to the stationary tray in the non-sort mode.
(1)
Turn OFF the power of the equipment.
(2)
Remove 1 screw and take off the board access cover.
(3)
Set the SW1 on the Finisher control board as shown in the figures below.
(4)
Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
e-STUDIO281c/351c/451c
ADJUSTMENT
Access cover
Fig. 3-99
ON
1
2
3
4
Fig. 3-100
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 100
06/08
SW1