Table of Contents
Advertisement
13. FUSER UNIT
13.1 General Description
In the fuser unit, toner is fused by applying heat and pressure on the transferred image on the trans-
ported paper. The paper is then transported to the paper exit section after completion of fusing. The
fuser unit consists of the heater lamps, fuser roller, pressure roller, separation fingers, cleaning roller,
thermistors, thermostat, etc.
Separation finger
Fuser roller
Center heater lamp
Side heater lamp
Thermostat
Thermistor
June 2004 © TOSHIBA TEC
Fig.13-1
13 - 1
Paper exit section
Pressure roller
Cleaning roller
Fuser unit
e-STUDIO200L/230/280 FUSER UNIT
13
Advertisement
Table of Contents
