Ip Tunnel; Ne Autodiscovery - Alcatel-Lucent 1850 User Provisioning Manual

Menu bar
............................................................................................................................................................................................................................................................
Figure 3-51 IP tunnel
The IP Tunnel Configuration tab displays the following:
AID - Refers about the access identifier of the LSP tunnel for the network connection.
•
It is assigned by system at connection creation. Format is as follows: <Source Node
ID> or <Destination Node ID>: <Four dot separated numeric string> <Tunnel ID> or
<Tunnel Instance>: <One numeric string> in the 0 to 255 range for each numeric
string.
Remote NSAP - Specifies the Network Service Access Point for the IP Tunnel
•
Encapsulation Type - Specifies the Encapsulation Type required for the Tunnel
•
configuration
The Delete link allows to remove from the list the selected item by the check box.
The Create link allows to configure a new IP Tunnel. See

NE autodiscovery

The NE Auto Discovery displays the following as shown in
Figure 3-52 NE autodiscovery
The NE Auto Discovery tab displays the Autodiscovery panel that contains the following
parameters:
ENABLED - To enable or disable the NE Autodiscovery. The values are:
•
– Y - To enable the NE Auto Discovery
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
"Create IP tunnel" (p. 5-57).
Figure 3-52.
Xcom menu
3 - 5 7