Honda ACCORD HYBRID 2005 Service Manual page 182

Engine Block
C r a n k s h a f t I n s p e c t i o n ( c o n t ' d ) B l o c k a n d P i s t o n I n s p e c t i o n
Straightness
6. Place the engine block on the surface plate.
7. Clean and install the bearings on the No. 1 and
No. 4 journal of the engine block.
8. Lower the crankshaft into the block.
9. Measure the runout on all of the main journals.
Rotate the crankshaft t w o complete revolutions.
The difference between measurements on each
journal must not be more than the service limit.
Crankshaft Total Runout
Standard (New): 0.025 mm (0.0010 in.) max.
Service Limit: 0.030 mm (0.0012 in.)
1. Remove the piston f r o m the engine block (see page
7-13).
2. Check the piston for distortion or cracks.
3. Measure the piston diameter at a point 16.0 m m
(0.63 in.) f r o m the b o t t o m of the skirt.
Piston Diameter
Standard (New): 85.975—85.985 mm
(3.3848-3.3852 in.)
Service Limit: 85.965 mm (3.3844 in.)
Oversize Piston Diameter
0.25: 86.225-86.235 mm (3.3947-3.3951 in.)
0.50: 86.475-86.485 mm (3.4045-3.4049 in.)
16.0 m m
(0.63 in.)
SKIRT DIAMETER
7-16