Crankshaft Inspection - Honda ACCORD HYBRID 2005 Service Manual

C r a n k s h a f t I n s p e c t i o n
16. Remove the bearing cap bolts (A) and bearing cap
side bolts (B), then remove the bearing cap (C).
17. Lift the crankshaft (A) out of the engine block, being
careful not to damage the journals.
18. Reinstall the main caps and bearings on the engine
block in the proper order.
Out-of-Round and Taper
1. Remove the crankshaft f r o m the engine block
{see page 7-13).
2. Clean the crankshaft oil passages w i t h pipe
cleaners or a suitable brush.
3. Check the keyway and threads.
4. Measure out-of-round at the middle of each rod
and m a i n journal in t w o places. The difference
between measurements on each journal m u s t not
be more than the service limit.
Journal Out-of-Round
Standard (New): 0.005 mm (0.0002 in.) max.
Service Limit: 0.010 mm (0.0004 in.)
"i
p
n
r
Measure taper at the edges of each rod and main
journal. The difference between measurements on
each journal must not be more than the service
limit.
Journal Taper
Standard (New): 0.005 mm (0.0002 in.) max.
Service Limit: 0.010 mm (0.0004 in.)
(cont'd)
7-15