Portmode Hybrid - Dell S4810 Reference Manual

Layer 2 Overhead
Ethernet
(untagged)
VLAN Tag
Untagged Packet
with VLAN-Stack
Header
Tagged Packet
with VLAN-Stack
Header

portmode hybrid

To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this
way is identified as a hybrid port in report displays.
S4810
Syntax
portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the
no portmode hybrid command.
Defaults non-hybrid
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Usage
The following describes the interface command shown in the following
Information
example. This example sets a port as hybrid, makes the port a tagged member of
VLAN 20, and an untagged member of VLAN 10, which becomes the native VLAN
of the port. The port now accepts:
Interfaces
Link MTU and IP MTU Delta
18 bytes
22 bytes
22 bytes
26 bytes
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
769