File Management; Boot System - Dell S4810 Reference Manual

File Management

This chapter contains command line interface (CLI) commands needed to manage the configuration files
as well as other file management commands.

boot system

Tell the system where to access the Dell Networking OS image used to boot the system.
S4810
Syntax
boot system {gateway ip address| stack-unit [{0-11 | 0-7]| all]
[default | primary {system {A: | B:} | tftp: | | secondary]}
To return to the default boot sequence, use the no boot system command.
Parameters
gateway
ip-address
stack-unit
0-11, 0-7, all
default
primary
secondary
tftp:
A: | B:
Defaults Not configured.
Command CONFIGURATION
Modes
62
Enter the IP address of the default next-hop gateway for the
management subnet.
Enter an IP address in dotted decimal format.
Enter the stack-unit number for the master switch.
Enter the stack-unit number. The S4810 range is from 0 to
11.
Enter the keyword default to use the primary Dell
Networking OS image.
Enter the keyword primary to use the primary Dell
Networking OS image.
Enter the keyword secondary to use the primary Dell
Networking OS image.
Enter the keyword TFTP: to retrieve the image from a TFTP
server. tftp://hostip/filepath.
Enter A: or B: to boot one of the system partitions.
3
File Management