Spanning Tree Protocol Commands; Stp Configuration Commands; Spanning-Tree - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

This section describes the spanning tree protocol (STP) commands available in the 7200R
Series Managed Switch CLI. STP helps prevent network loops, duplicate messages, and
network instability.
The STP Commands section includes the following topics:
• Section 5.1 "STP Configuration Commands" on page 5-1
• Section 5.2 "STP Show Commands" on page 5-10
The commands in this section are in one of two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.

5.1 STP Configuration Commands

This section describes the commands you use to configure Spanning Tree Protocol (STP).
Note: STP is enabled by default. If STP is disabled, the system does not generate

5.1.1 spanning-tree

This command sets the spanning-tree operational mode to enabled.
Default
Format
Mode

Spanning Tree Protocol Commands

Spanning Tree Protocol Commands
BPDU messages.
enabled
spanning-tree
Global Config
v1.0, November 2007
Chapter 5
5-1