Spanning Tree Protocol (Stp) Commands - NETGEAR ProSafe GSM7228PS Cli Manual

Spanning Tree Protocol (STP) Commands

This section describes the commands you use to configure Spanning Tree Protocol (STP). STP
helps prevent network loops, duplicate messages, and network instability.
spanning-tree
This command sets the spanning-tree operational mode to enabled.
Default enabled
Format
spanning-tree
Mode Global Config
no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the spanning-
tree configuration is retained and can be changed, but is not activated.
Format
no spanning-tree
Mode Global Config
spanning-tree bpdufilter default
Use this command to enable BPDU Filter on all the edge port interfaces.
Default disabled
Format
spanning-tree bpdufilter
Mode Global Config
no spanning-tree bpdufilter default
Use this command to disable BPDU Filter on all the edge port interfaces.
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-10