Toyota T100 1996 Service Manual page 651

4 Check D squib.
Center Airbag
Sensor Assembly
ACC
or
DLC1
E1
Tc
H00352
AB0118 AB0119
S08098 W02044
OK
From results of above inspection, malfunctioning part can now be considered normal.
To make sure of this, use simulation method to check.
1996 TOYOTA T100 (RM449U)
DIAGNOSTICS
D Squib
Spiral
Cable
ON
Code 14
H00339
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Turn ignition switch to LOCK.
(b) Disconnect negative (−) terminal cable from the battery,
and wait at least 90 seconds.
(c) Connect steering wheel pad connector.
(d) Connect negative (−) terminal cable to battery, and wait
at least 2 seconds.
CHECK:
(a) Turn ignition switch to ACC or ON, and wait at least 20 se-
conds.
(b) Clear malfunction code stored in memory (See page
DI−365).
(c) Turn ignition switch to LOCK, and wait at least 20 se-
conds.
(d) Turn ignition switch to ACC or ON, and wait at least 20 se-
conds.
(e) Using SST, connect terminals Tc and E1 of DLC1.
SST 09843−18020
(f) Check DTC.
OK:
DTC 14 is not output.
HINT:
Codes other than code 14 may be output at this time, but they
are not relevant to this check.
NG Replace steering wheel pad.
DI−387