Toyota T100 1996 Service Manual page 656

DI−392
4 Check center airbag sensor assembly.
Center Airbag
Sensor Assembly
ACC
or
DLC1
E1
Tc
H00350
AB0118 AB0119
S08098 H00316
OK
From results of above inspection, malfunction part can now be considered normal.
To make sure of this, use simulation method to check.
5 Check connection of center airbag sensor assembly connector.
OK
1996 TOYOTA T100 (RM449U)
DIAGNOSTICS
D Squib
Spiral
Cable
ON
Code 15
H00340
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Connect center airbag assembly connector.
(b) Connect negative (−) terminal cable to battery, and wait
at least 2 seconds.
CHECK:
(a) Turn ignition switch to ACC or ON, and wait at least 20 se-
conds.
(b) Clear malfunction code stored in memory (See page
DI−365).
(c) Turn ignition switch to LOCK, and wait at least 20 se-
conds.
(d) Turn ignition switch to ACC or ON, and wait at least 20 se-
conds.
(e) Using SST, connect terminals Tc and E1 of DLC1.
SST 09843−18020
(f) Check DTC.
OK:
DTC 15 is not output.
HINT:
Codes other than code 15 may be output at this time, but they
are not relevant to this check.
NG Replace center airbag sensor assembly.
NG Repair.