Show Ipv6 Interface - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ipv6 interface

show ipv6 interface
Displays IPv6 Interface Table.
show ipv6 interface [if_name | loopback]
Syntax Definitions
if_name
loopback
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If you do not specify an interface name, all IPv6 interfaces are displayed.
•
Specify an interface name (e.g., VLAN 12) to obtain a more detailed information about a specific inter-
face.
Examples
-> show ipv6 interface
Name
--------------------+----------------------------------------+---------+--------
smbif-5
v6if-to-eagle
tunnel_6to4
v6if-tunnel-137
loopback
output definitions
Name
IPv6 Address/Prefix Length
Status
Device
page 11-32
Interface name. Limits the display to a specific interface.
Limits display to loopback interfaces.
IPv6 Address/Prefix Length
fe80::2d0:95ff:fe12:f470/64
212:95:5::35/64
212:95:5::/64
fe80::2d0:95ff:fe12:f470/64
195:35::35/64
195:35::/64
2002:d423:2323::35/64
2002:d423:2323::/64
fe80::2d0:95ff:fe12:f470/64
137:35:35::35/64
137:35:35::/64
::1/128
Interface name. This is usually the VLAN on which the interface is
configured.
IPv6 address and prefix length assigned to the interface. If an interface
has more than one IPv6 address assigned to it, each address is shown on
a separate line.
Interface status (e.g., Active/Inactive).
The device on which the interface is configured (e.g., VLAN 955).
Status
Active
Disabled
Active
Disabled
Active
Active
OmniSwitch CLI Reference Guide
IPv6 Commands
Device
VLAN 955
VLAN 1002
6to4 Tunnel
Tunnel 2
loopback
Loopback
March 2011