Table 195: Gvrp Timer Settings - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Table 195: GVRP Timer Settings

Field Function
Join Timer Specifies the maximum number of milliseconds the interface waits
before sending VLAN advertisements.
Leave Timer Specifies the number of milliseconds an interface waits after
receiving a leave message before the interface leaves the VLAN
specified in the message.
Leave All Timer Specifies the interval in milliseconds at which Leave All messages
are sent on interfaces. Leave All messages help to maintain current
GVRP VLAN membership information in the network.
Disable GVRP Disables GVRP on all interfaces.
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
As individual interfaces become active and send requests to join a VLAN, the VLAN
configuration is updated and propagated among the switches. Limiting the VLAN
configuration to active participants reduces the network overhead. GVRP also provides
the benefit of pruning VLANs to limit the scope of broadcast, unknown unicast, and
multicast (BUM) traffic to interested network devices only.
To configure GVRP using the J-Web interface:
Select
1. Configure > Switching > GVRP
are listed.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select Commit Options > Commit. See Using
the Commit Options to Commit Configuration Changes for details about
all commit options.
To enable GVRP on an interface, click
2.
from the Interface Out of GVRP
To modify GVRP timers, click
3.
the interface, enter information as described in Table 195 on page 1387.
Click OK to apply changes to the configuration or click
4.
changes.
To disable an interface, select the interface and click
Example: Configure Automatic VLAN Administration Using GVRP on page 1329
Chapter 59: Configuring Bridging and VLANs
. Interfaces on which GVRP has been enabled
. Click the arrow key to move the interface
Add
list to the Interface under GVRP
. For modifying GVRP Timer settings for
Global Settings
Cancel
Disable Port
Your Action
Type a number.
Type a number.
Type a number.
To disable GVRP, select the check
box.
To enable GVRP, clear the check
box.
list, and click OK .
to cancel without saving
.
1387