policy action priority
Configures the priority for queuing a flow to which the QoS action applies.
policy action action_name priority priority_value
policy action action_name no priority
Syntax Definitions
action_name
priority_value
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a priority value from an action.
•
This priority value is independent of 802.1Q, Type of Service (ToS), or Differentiated Services Code
Point (DSCP) values.
•
Note that the value displayed on the
here.
Examples
-> policy action action1 priority 1
-> policy action action1 no priority
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
page 39-116
The name of the action.
The priority given to scheduling traffic on the output port. Values range
from 0 (lowest) to 7 (highest).
show qos queue
screen may be different from the value entered
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about actions configured on the switch.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009