Preemption Delay - HP E4510-48G Command Reference Manual

master: Specifies the port as the master port.
slave: Specifies the port as the slave port.
Description
Use the port smart-link group command to configure the current port as a member of the specified
smart link group.
Use the port smart-link group command to remove the port from the specified smart link group.
Note that:
Disable STP and RRPP on the ports you want to add to the smart link group, and make sure that
the ports are not member ports of any aggregation group or service loopback group. On the other
hand, you cannot enable STP or RRPP on a smart link group member port or assign a smart link
group member port to an aggregation group or service loopback group.
You can assign a port to a smart link group with the port command in smart link group view.
Related commands: port.
Examples
# Configure GigabitEthernet 1/0/1 as the master port of smart link group 1.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1] protected-vlan reference-instance 0
[Sysname-smlk-group1] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo stp enable
[Sysname-GigabitEthernet1/0/1] port smart-link group 1 master
# Configure Layer-2 aggregate interface 1 as the master port of smart link group 1.
<Sysname> system-view
[Sysname] smart-link group 1
[Sysname-smlk-group1] protected-vlan reference-instance 0
[Sysname-smlk-group1] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] undo stp enable
[Sysname-Bridge-Aggregation1] port smart-link group 1 master

preemption delay

Syntax
preemption delay delay-time
undo preemption delay
View
Smart link group view
Default Level
2: System level
1-5