Source Ip - HP E4510-48G Command Reference Manual

Description
Use the source interface command to specify the IP address of an interface as the source IP address
of ICMP echo probe requests.
Use the undo source interface command to remove the IP address of an interface as the source IP
address of ICMP echo probe requests.
By default, no interface address is specified as the source IP address of ICMP test request packets.
Note that:
If you use the source ip command to configure the source IP address of ICMP probe requests,
the source interface command is invalid.
The interface specified by the source interface command must be up; otherwise, the probe fails.
Related commands: source ip.
Examples
# Specify the IP address of interface VLAN-interface 2 as the source IP address of ICMP echo probe
requests.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source interface vlan-interface 2

source ip

Syntax
source ip ip-address
undo source ip
View
DLSw, FTP, HTTP, ICMP echo, SNMP, TCP, UDP echo, UDP jitter, voice test type view
Default Level
2: System level
Parameters
ip-address: Source IP address of a test operation.
Description
Use the source ip command to configure the source IP address of ICMP probe requests in a test
operation.
Use the undo source ip command to remove the configured source address. That is, the IP address
of the interface sending a probe request serves as the source IP address of the probe request.
By default, no source IP address is specified.
Note that:
For an ICMP echo test, if no source IP address is specified, but the source interface is specified,
the IP address of the source interface is taken as the source IP address of ICMP probe requests.
18-31