HP E4510-48G Command Reference Manual page 1291

undo cluster-snmp-agent usm-user v3 user-name group-name
View
Cluster view
Default Level
1: Monitor level
Parameters
user-name: User name, a string of 1 to 32 characters.
group-name: Group name, a string of 1 to 32 characters.
authentication-mode: Specifies the security level to be authentication needed.
md5: Specifies the authentication protocol to be HMAC-MD5-96.
sha: Specifies the authentication protocol to be HMAC-SHA-96.
auth-password: Authentication password, a string of 1 to 16 characters if in plain text; it can only be a
string of 24 characters if in cipher text.
privacy-mode: Specifies the security level to be encrypted.
des56: Specifies the encryption protocol to be DES (data encryption standard).
priv-password: Encryption password, a string of 1 to 16 characters in plain text; it can only be a string
of 24 characters in cipher text.
Description
Use the cluster-snmp-agent usm-user v3 command to add a new user to the SNMP v3 group shared
by a cluster.
Use the undo cluster-snmp-agent usm-user v3 command to delete the SNMP v3 group user shared
by the cluster.
Note that:
The command can be executed once on the management device only. This configuration will be
synchronized to member devices on the whitelist, which is equal to configuring multiple member
devices at one time.
SNMPv3 group user will be retained if a cluster is dismissed or a member device is deleted from
the whitelist.
If the same username as the current one has been configured on a member device, the current
username will replace the original one on the member device.
Examples
# Add a user wang to the SNMP group snmpgroup, set the security level to authentication-needed
and specify the authentication protocol as HMAC-MD5-96 and authentication password as pass.
<aaa_0.Sysname> system-view
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] cluster-snmp-agent usm-user v3 wang snmpgroup authentication-mode
md5 pass
20-27