Ethernet Oam Configuration Commands; Display Oam - HP E4510-48G Command Reference Manual

5

Ethernet OAM Configuration Commands

OAM Configuration Commands

display oam

Syntax
display oam { local | remote } [ interface interface-type interface-number ]
View
Any view
Default Level
2: System level
Parameters
local: Displays the Ethernet OAM connection information of the local end.
remote: Displays the Ethernet OAM connection information of the remote end.
interface interface-type interface-number: Specify a port by its type and number.
Description
Use the display oam command to display the information about an Ethernet OAM connection,
including connection status, information contained in Ethernet OAM packet header, and Ethernet OAM
packet statistics.
If you do not specify the interface keyword, this command displays the information about all the
Ethernet OAM connections.
Related commands: reset oam.
Examples
# Display the information about the Ethernet OAM connection established on the local port
GigabitEthernet 1/0/1.
<Sysname> display oam local interface gigabitethernet 1/0/1
Port : GigabitEthernet1/0/1
Link Status : Up
EnableStatus
Local_oam_mode
Local_mux_action
OAMLocalFlagsField :
--------------------------------------------------------------------------
Link Fault
Critical Event
: Enable
: Active Local_pdu
: FWD Local_par_action
: 0 Dying Gasp
: 0 Local Evaluating
5-1
: ANY
: FWD
: 0
: COMPLETE