Host-Aging-Time (Mld-Snooping View) - HP E4510-48G Command Reference Manual

vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id
to end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of
a VLAN ID is 1 to 4094.
Description
Use the group-policy command to configure a global IPv6 multicast group filter, namely to control the
IPv6 multicast groups a host can join.
Use the undo group-policy command to remove the configured global IPv6 multicast group filter.
By default, no IPv6 multicast group filter is configured globally, namely any host can join any valid IPv6
multicast group.
Note that:
If you do not specify any VLAN, the command will take effect for all VLANs; if you specify a VLAN
or multiple VLANs, the command will take effect for the specified VLAN(s) only.
If the specified IPv6 ACL does not exist or the ACL rule is null, all IPv6 multicast groups will be
filtered out.
You can configure different IPv6 ACL rules for each port in different VLANs; for a given VLAN, a
newly configured IPv6 ACL rule will override the existing one.
Related commands: mld-snooping group-policy.
Examples
# Apply ACL 2000 as an IPv6 multicast group filter in VLAN 2 so that hosts in this VLAN can join
ff03::101 only.
<Sysname> system-view
[Sysname] acl ipv6 number 2000
[Sysname-acl6-basic-2000] rule permit source ff03::101 16
[Sysname-acl6-basic-2000] quit
[Sysname] mld-snooping
[Sysname-mld-snooping] group-policy 2000 vlan 2

host-aging-time (MLD-Snooping view)

Syntax
host-aging-time interval
undo host-aging-time
View
MLD-Snooping view
Default Level
2: System level
Parameters
interval: Dynamic member port aging time, in units of seconds. The effective range is 200 to 1,000.
3-5