If-Match Ip-Prefix; Ip Ip-Prefix - HP E4510-48G Command Reference Manual

Examples
# Configure node 10 of route policy policy1 to permit routing information whose next hop address
matches IP prefix list p1.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match ip next-hop ip-prefix p1

if-match ip-prefix

Syntax
if-match ip-prefix ip-prefix-name
undo if-match ip-prefix
View
Route policy view
Default Level
2: System level
Parameters
ip-prefix-name: Matches an IP prefix list with a name being a string of 1 to 19 characters.
Description
Use the if-match ip-prefix command to configure an IP prefix list based match criterion.
Use the undo if-match ip-prefix command to remove the match criterion.
No IP prefix list based match criterion is configured by default.
Related commands: if-match interface, if-match ip next-hop, if-match cost, if-match tag,
route-policy, apply ip-address next-hop, apply cost, apply tag.
Examples
# Configure node 10 of route policy policy2 to permit routes whose destination address matches IP
prefix list p1.
<Sysname> system-view
[Sysname] route-policy policy2 permit node 10
[Sysname-route-policy] if-match ip-prefix p1

ip ip-prefix

Syntax
ip ip-prefix ip-prefix-name [ index index-number ] { permit | deny } ip-address mask-length
[ greater-equal min-mask-length ] [ less-equal max-mask-length ]
undo ip ip-prefix ip-prefix-name [ index index-number ]
View
System view
6-10