Subvlan (Multicast Vlan View) - HP E4510-48G Command Reference Manual

Description
Use the port multicast-vlan command to assign the current port(s) to the specified multicast VLAN.
Use the undo port multicast-vlan command to restore the system default.
By default, a port does not belong to any multicast VLAN.
Note that a port can belong to only one multicast VLAN.
Examples
# Assign GigabitEthernet1/0/1 to multicast VLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet1/0/1
[Sysname- gigabitethernet1/0/1] port multicast-vlan 100

subvlan (multicast VLAN view)

Syntax
subvlan vlan-list
undo subvlan { all | vlan-list }
View
Multicast VLAN view
Default Level
2: System level
Parameters
vlan-list: Specifies a VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to
end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of a
VLAN ID is 1 to 4094.
all: Deletes all the sub-VLANs of the current multicast VLAN.
Description
Use the subvlan command to configure sub-VLAN(s) for the current multicast VLAN.
Use the undo subvlan command to remove the specified sub-VLAN(s) or all sub-VLANs from the
current multicast VLAN.
A multicast VLAN has no sub-VLANs by default.
Note that:
The VLANs to be configured as sub-VLANs of the multicast VLAN must exist and must not be
multicast VLANs or sub-VLANs of another multicast VLAN.
The number of sub-VLANs of the multicast VLAN must not exceed 63
Examples
# Configure VLAN 10 through VLAN 15 as sub-VLANs of multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan 100
2-4