Ripng Summary-Address; Timers - HP E4510-48G Command Reference Manual

[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng split-horizon

ripng summary-address

Syntax
ripng summary-address ipv6-address prefix-length
undo ripng summary-address ipv6-address prefix-length
View
Interface view
Default Level
2: System level
Parameters
ipv6-address: Destination IPv6 address of the summary route.
prefix-length: Prefix length of the destination IPv6 address of the summary route, in the range of 0 to
128. It indicates the number of consecutive 1s of the prefix, which defines the network ID.
Description
Use the ripng summary-address command to configure a summary network to be advertised through
the interface.
Use the undo ripng summary-address command to remove the summary.
Networks falling into the summary network will not be advertised. The cost of the summary route is the
lowest cost among summarized routes.
Examples
# Assign an IPv6 address with the 64-bit prefix to VLAN-interface 100 and configure a summary with
the 35-bit prefix length.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address 2001:200::3EFF:FE11:6770/64
[Sysname-Vlan-interface100] ripng summary-address 2001:200:: 35

timers

Syntax
timers { garbage-collect garbage-collect-value | suppress suppress-value | timeout timeout-value |
update update-value } *
undo timers { garbage-collect | suppress | timeout | update } *
View
RIPng view
5-15