Ssh Client Ipv6 Source - HP E4510-48G Command Reference Manual

Parameters
None
Description
Use the ssh client first-time enable command to enable the first authentication function.
Use the undo ssh client first-time command to disable the function.
By default, the function is enabled.
With first-time authentication, when an SSH client not configured with the server host public key
accesses the server for the first time, the user can continue accessing the server, and save the host
public key on the client. When accessing the server again, the client will use the saved server host
public key to authenticate the server.
Without first-time authentication, a client not configured with the server host public key will deny to
access the server. To access the server, a user must configure in advance the server host public key
locally and specify the public key name for authentication.
Note that as the server may update its key pairs periodically, clients must obtain the most recent public
keys of the server for successful authentication of the server.
Examples
# Enable the first authentication function.
<Sysname> system-view
[Sysname] ssh client first-time enable

ssh client ipv6 source

Syntax
ssh client ipv6 source { ipv6 ipv6-address | interface interface-type interface-number }
undo ssh client ipv6 source
View
System view
Default Level
3: Manage level
Parameters
ipv6 ipv6-address: Specifies a source IPv6 address.
interface interface-type interface-number: Specifies a source interface by its type and number.
Description
Use the ssh client ipv6 source command to specify the source IPv6 address or source interface for
the SSH client.
Use the undo ssh client ipv6 source command to remove the configuration.
By default, the client uses the source address specified by the route of the device to access the SSH
server.
10-11