Version - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the validate-source-address command to enable the source IP address validation on incoming
RIP routing updates.
Use the undo validate-source-address command to disable the source IP address validation.
The source IP address validation is enabled by default.
RIP checks whether the source IP address of the packet is on the same network segment as the
interface IP address; if not, the packet is discarded.
Generally, disabling the validation is not recommended.
Examples
# Disable the source IP address validation on incoming RIP routing updates.
<Sysname> system-view
[Sysname-rip] rip 100
[Sysname-rip-100] undo validate-source-address

version

Syntax
version { 1 | 2 }
undo version
View
RIP view
Default Level
2: System level
Parameters
1: Specifies the RIP version as RIPv1.
2: Specifies the RIP version as RIPv2. RIPv2 messages are multicast.
Description
Use the version command to specify a global RIP version.
Use the undo version command to remove the configured global RIP version.
By default, if an interface has a RIP version specified, the RIP version takes effect; if it has no RIP
version specified, it can send RIPv1 broadcasts, and receive RIPv1 broadcasts, RIPv1 unicasts, RIPv2
broadcasts, RIPv2 multicasts, and RIPv2 unicasts.
Note that:
3-28