Ntdp Enable; Ntdp Explore - HP E4510-48G Command Reference Manual

00e0-fc00-5111 GigabitEthernet1/0/1
Refer to Table 20-4

ntdp enable

Syntax
ntdp enable
undo ntdp enable
View
System view, Ethernet interface view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
None
Description
Use the ntdp enable command to enable NTDP.
Use the undo ntdp enable command to disable NTDP.
By default, NTDP is enabled globally and on all ports.
Note that:
Execution of the command in system view enables the global NTDP; execution of the command in
interface view enables NTDP of the current port.
Configured in Layer 2 aggregate interface view, the configuration will not take effect on the
member ports of the aggregation group that corresponds to the aggregate interface; configured on
a member port of an aggregation group, the configuration will take effect only after the member
port quit the aggregation group. For description of aggregation configurations, refer to Link
Aggregation Configuration in the Access Volume.
Examples
# Enable NTDP globally.
<Sysname> system-view
[Sysname] ntdp enable
# Enable NTDP for port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ntdp enable

ntdp explore

Syntax
ntdp explore
for the description of the above prompt information.
GigabitEthernet2/0/45
20-11
1000 FULL