ring enable
Syntax
ring ring-id enable
undo ring ring-id enable
View
RRPP domain view
Default Level
2: System level
Parameters
ring-id: RRPP ring ID, in the range 1 to 64.
Description
Use the ring enable command to enable the RRPP ring.
Use the undo ring enable command to disable the RRPP ring.
By default, the RRPP ring is disabled.
Note that:
To enable subrings, you must first enable the primary ring before enabling subrings.
You must first disable all the subrings in the RRPP domain and then disable the primary ring.
To activate the RRPP domain, enable the RRPP protocol and the RRPP rings for the RRPP
domain.
Related commands: rrpp enable.
Examples
# Enable RRPP ring 10 in RRPP domain 1.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 100
[Sysname-rrpp-domain1] protect-vlan reference-instance 0 1 2
[Sysname-rrpp-domain1]
secondary-port gigabitethernet 1/0/2 level 0
[Sysname-rrpp-domain1] ring 10 enable
rrpp domain
Syntax
rrpp domain domain-id
undo rrpp domain domain-id
View
System view
ring
10
node-mode
3-15
master
primary-port
gigabitethernet
1/0/1