Display Rip Interface - HP E4510-48G Command Reference Manual

Field
Rip-interface
imported

display rip interface

Syntax
display rip process-id interface [ interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
interface-type interface-number: Specifies an interface.
Description
Use the display rip interface command to display the RIP interface information of the RIP process.
If no interface is specified, information about all RIP interfaces of the RIP process is displayed.
Examples
# Display all the interface information of RIP process 1.
<Sysname> display rip 1 interface
Interface-name: Vlan-interface1
Address/Mask:1.1.1.1/24
MetricIn:5
MetricOut:5
Split-horizon/Poison-reverse:on/off
Default route:off
Current packets number/Maximum packets number:234/2000
Table 3-3 display rip interface command output description
Interface-name
Address/Mask
Version
MetricIn
MetricIn route policy
Routes learnt from a RIP–enabled interface
Routes redistributed from other routing protocols
MetricIn route policy:123
MetricOut route policy:234
Field
Description
Version:RIPv1
Input/Output:on/on
Description
The name of an interface running RIP
IP address and mask of the interface
RIP version running on the interface
Additional routing metric added to the incoming routes
Name of the routing policy used to add the additional
routing metric for the incoming routes. If no routing policy
is referenced, the field displays Not designated.
3-6