Display Ip Routing-Table Acl - HP E4510-48G Command Reference Manual

Field
State
Age
Tag

display ip routing-table acl

Syntax
display ip routing-table acl acl-number [ verbose ]
View
Any view
Route status:
Active This is an active unicast route.
Adv This route can be advertised.
Delete This route is deleted.
Gateway This is an indirect route.
Number of holddown routes. Holddown is a route
advertisement policy used in some distance vector (D-V)
routing protocols, such as RIP, to avoid the propagation of
Holddown some incorrect routes. It distributes a Holddown route during
a period regardless of whether a new route to the same
destination is found. For details, refer to corresponding
routing protocols.
The route was discovered by an Interior Gateway Protocol
Int
(IGP).
The route is not advertised when the router advertises routes
NoAdv
based on policies.
Normally, among routes to a destination, the route with the
highest priority is installed into the core routing table and
NotInstall
advertised, while a NotInstall route cannot be installed into
the core routing table but may be advertised.
The packets matching a Reject route will be dropped.
Besides, the router sends ICMP unreachable messages to
Reject
the sources of the dropped packets. The Reject routes are
usually used for network testing.
A static route is not lost when you perform the save operation
Static and then restart the router. Routes configured manually are
marked as static.
Unicast Unicast routes
Inactive Inactive routes
Invalid Invalid routes
WaitQ The route is the WaitQ during route recursion.
TunE Tunnel
GotQ The route is in the GotQ during route recursion.
Time for which the route has been in the routing table, in the sequence of
hour, minute, and second from left to right.
Route tag
Description
1-4